Monday 16 January 2012

New to me parts cleaner

I just received a Harbor Freight Tools parts cleaner for free for Justin M. Thanks Justin.

I asked my friend, Tom G., what solution he uses and he responded:

For parts washing, I use the solvent based cleaners supplied by McMaster Carr:
Solvent-Based Solutions— These solutions remove grease, motor oil, cutting oil, water-soluble oil, soft gummy deposits, and buffing and lapping compounds from metal, plastic, and painted surfaces. They have a mild odor and contain no chlorinated solvents. These products are compliant under all state VOC rules in effect on January 1, 2011, except in California. Caution: Do not heat. Use only at room temperature.
Solvent-plus-lanolin formula contains lanolin to reduce skin irritation and chapping. Leaves a corrosion-resistant film on parts. Nitrile gloves should be worn for prolonged use. Flash point is 105° F.
High-flash-point lanolin formula is for when local regulations require a higher flash point. It has a flash point of 141° F.
Solvent-Based Solutions
SizeEach
Solvent-Plus-Lanolin Formula
5 gal.
3229K1$95.22
50 gal.
3229K3859.66
High-Flash-Point Formula
5 gal.
3457K11$91.92
50 gal.
3457K23812.63
Unfortunately, I live in California so that will not work for me. I asked Mike A., who is local to Calif. and he suggested:

"Solvent, don't use the harbor freight junk. Call around to machine shops and see what they use. They probably have a service that changes out their tanks for them but some times they have extra on the shelf and might be willing to give or sell you some. Keep in mind good solvent is expensive. Easily over $5 per gal. Also it will evaporate so keep it closed up. The trick to making solvent last is to only use it for finish cleaning, so no greasy cases!"

My uncle has restored cars for decades and for the longest time has run kerosene through his parts washer and its pump. There are many considerations that need to take place before acting on this and then some serious planning, due to the explosive nature of kerosene and as Mike A. said "Just be sure to use gloves as the benzine in the kerosene has a cumulative affect and can cause problems later on tumors etc.".

At this point I will try Freecycle and my local machine shops.

No comments:

Post a Comment