Glove box door on frame

Today I installed the glove box to the frame. I used stainless 4mm hardware. I did not take the time to find out what stock hardware size would be. I also used lock washers and washers with this. With I Dremel I removed the hardware stamp on the visible screws.
Note: this picture needs to be rotated. The fender is on the bottom of the picture and the frame is on the top. The reason for this is because, I didn't look at that parts manual to see that I needed double the amount of nuts. You need two nuts per screw. The angle of the screw is not flush. The first nut locks the screw flush with the frame and the second screw (which I believe is similar to a lock nut) locks the glove box to the frame. I worried about the clearance of the fender to this screw, but after looking it over quite a bit I believe I should be good.

I need to buy four new nuts and washers and then redo this job. Should be easier without the screws spinning.