Barry Gwin's Vespa Clutch Compressor Tool

I called First Kick Scooters yesterday to see if they had a clutch compressor tool in stock. They did not, but I was told they just use a bolt with washers and nuts to compress clutches that come in their shop.



Then I called SF Scooter Centre and they had them in stock for $20. I stopped by to pick one up as opposed to risking damaging mine without the correct tool and Barry said, make your own. Don't buy this $20 one. He usually sells his Home Depot version ones for $5, but was all out. He drew up his design and sent me on my way.



It costs me $2.25 to make and I tested it in Home Depot and it worked great. Here's what I bought:

- 1/2 inch wing nut

- two 1/2 inch washes

- 1/2x3 inch carriage bolt



The idea is the taper on the carriage bolt is similar to the taper in the clutch. I made sure that my carriage bolt easily and freely turned so it would not score my taper in my clutch. So I guess in theory this is just like using washers, nuts, and a bolt, because my taper is not fitting the sleeve perfectly. I quickly compress, remove the circlip, and release the pressure in case this design puts undue pressure on the clutch since it is not pulling from the sleeve. I do know it is not in contact with the brass ring nut as it sits on the lip above it.



I hit Ace Hardware up yesterday, but they did not have large enough carriage bolts, so I used washers, nuts and a bolt and it worked fine if you're in a jam.