Above is the plan designed by Kieran Walsh& Stewart Nicol.
The extractor is on the left side and the installer is on the right.
Here is the tricky cut outs to fit the engine case.
2 inch section.
2 and 1/2 inch section.Thanx for sharing Kieran.
Sunday, 26 July 2009
Lambretta tool: Kieran Walsh's & Stewart Nicol's silent block extractor/installer
Below is one of the best homemade designed silent block extractor/installer tool. You can purchase these parts at Home Depot or alike in the electrical, plumbing, and hardware sections and you will be able to make this tool at a fraction of the $70 it costs to buy this tool.
Above is the plan designed by Kieran Walsh& Stewart Nicol.
The extractor is on the left side and the installer is on the right.
Here is the tricky cut outs to fit the engine case.
2 inch section.
2 and 1/2 inch section.
Above is the plan designed by Kieran Walsh& Stewart Nicol.The extractor is on the left side and the installer is on the right.Here is the tricky cut outs to fit the engine case.2 inch section.2 and 1/2 inch section.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment